Skip to content

In preparation

BICCAPS - carbon into the reactor as a solution, not as a bubble

Carbon is delivered into the reactor dissolved. The gas step that slows down every photobioreactor is thereby removed.

The problem

A bubble passes through the reactor in a few seconds. At 420 ppm there is so little carbon dioxide in it that only a fraction dissolves in that time and the rest leaves at the surface. This is not a property of Helena - it is the weakest step in every photobioreactor, because gas transfer into liquid is slower than photosynthesis itself. At the Metropole Zličín shopping mall we measured it in operation: the limit was neither the culture nor the volume, but the carbon supply.

A concentrator at the inlet and smaller bubbles optimise that step. BICCAPS eliminates it.

The principle

Absorption and cultivation are separated into two vessels, and what flows between them is liquid, not gas.

In the absorber, a potassium carbonate solution absorbs carbon dioxide and bicarbonate is formed from it:

CO₂ + K₂CO₃ + H₂O → 2 KHCO₃

This is industrially established chemistry, known in gas cleaning as the Benfield process since the 1960s.1

The saturated medium is transferred into the reactor. The algae carry the bicarbonate into the cell, the enzyme carbonic anhydrase releases CO₂ from it for photosynthesis, and carbonate is left in the solution - the sorbent in its original form:

2 HCO₃⁻ → biomass + O₂ + CO₃²⁻

The regenerated medium goes back to the absorber. The loop closes.2

What flows between the vessels is not gas but the very medium in which the culture grows. The absorber saturates it and the pH falls, the reactor depletes it and the pH rises again - it is a pH swing on one liquid, not two different solutions. The transfer is tied to the harvest cycle: at the upper pH value part of the volume is drawn off, the cells are separated, the clarified medium passes through the absorption column and returns. With a swing depth of 0.2 to 0.5 mol/l, a litre of medium carries roughly 9 to 22 grams of CO₂, so delivering 2.7 kg CO₂ a day requires transferring 120 to 310 litres, i.e. a few litres an hour.3 That is the same order as the harvesting rate - the loop therefore adds no separate operation, it just hangs off the one already in service.

The elegance lies in what regenerates the sorbent. In chemical air capture it is a furnace at high temperature, in the order of hundreds of degrees Celsius.4 Here it is photosynthesis at room temperature.

What we gain

Absorption separated from cultivation. The absorber is a small column built for a single task. The reactor needs no gas distribution, only mixing.

The same productivity as with bubbling. In a direct comparison, a culture in a solution with 0.30 mol/l bicarbonate reached the same biomass production as the same culture bubbled with two-percent CO₂. The difference was not statistically significant.5

A carbon reservoir right in the medium. Bicarbonate at a concentration of 0.1 to 1 mol/l carries two to three orders of magnitude more dissolved carbon than a gas-sparged medium.6 The culture does not go hungry even at midday, and the absorber can work at night while the reactor works by day.

Smaller losses. At pH 9 to 10 there is a minimum of free CO₂ in the solution, so there is nothing to vent off. In a bubbled reactor more carbon leaves at the surface than the culture consumes.

An ecological gate. High pH suppresses bacteria and competing algae. That is precisely why spirulina has been grown in open ponds for decades.7 An open system thereby becomes a real option.

Suppression of bubble coalescence. High ionic strength prevents bubbles from merging - an effect we already exploit in the medium today.

What we do not know

The organism. Unadapted Chlorella vulgaris is inhibited above about pH 9, and BICCAPS works in the 9 to 11 band.89 Either we adapt the strain - it can be done, it takes generations and the growth rate usually falls - or we use spirulina, which lives in that regime naturally. We want to test both routes - each leads to a different product and a different market.

Medium chemistry at high pH. Phosphate precipitates, iron drops out. The chelate we use holds to about pH 11. The rest of the composition has to be recalculated.

Concentration. Today’s medium contains bicarbonate only as a buffer. BICCAPS works with it two orders of magnitude higher, which means different osmotics and further adaptation.

Rate of absorption from air. Carbonate is a weaker absorbent than hydroxide, and without a catalyst capture from ambient air is slow. From flue gas or a concentrated source it works straight away.10

Cell separation. Clarifying the medium before it enters the column is the same unsolved step as harvesting - it merely becomes a condition of operation rather than its end. Published work offers an elegant solution here: as the culture consumes bicarbonate the pH rises on its own and the cells flocculate. Whether that holds for our medium and our culture, we do not know.11

Where we stand

We are still in the preparation stage. We will run the adaptation line separately from the main reactor: a small volume, a gradual pH shift, measurement of the growth rate and a search for the point where the culture breaks. Meanwhile the main reactor runs the gas route. It is a side line outside the grant activities, but what we learn from it - the behaviour of the culture at high pH, medium chemistry, harvesting by flocculation - we will use in the main line as well.

We want to answer three questions with data, not with an estimate. How far up the strain can be adapted without losing productivity. What the absorption capacity of the solution is without a catalyst. And how chlorella fares against spirulina in this regime.

What it does not solve

The carbon ends up in biomass again. BICCAPS improves the weakest step of capture, not the durability of storage. That runs a different route - pyrolysis into biochar.


Footnotes

  1. The Benfield process - absorption of CO₂ by a hot K₂CO₃ solution, used industrially since the 1960s in syngas cleaning. ↩︎

  2. Chi, Z., O’Fallon, J. V., Chen, S. (2011). Bicarbonate produced from carbon capture for algae culture. Trends in Biotechnology, 29(11), 537-541. ↩︎

  3. A swing depth of 0.2-0.5 mol/l corresponds to 8.8-22 g CO₂ per litre of medium (44 g/mol). The target supply of 2.7 kg CO₂/day follows from a productivity of 2 g dry biomass/l/day in 760 l (the working volume of reactor 04). The swing depth is an estimate - published work uses 0.1 to 0.7 mol/l, with the highest productivity at 0.3 mol/l and the highest carbon utilisation at 0.1 mol/l (Zhu et al. 2018). ↩︎

  4. In chemical air capture the sorbent is regenerated by heating to a high temperature - in the calcium loop that means hundreds of degrees Celsius. ↩︎

  5. Chi, Z., Elloy, F., Xie, Y., Hu, Y., Chen, S. (2014). Selection of microalgae and cyanobacteria strains for bicarbonate-based integrated carbon capture and algae production system. Applied Biochemistry and Biotechnology, 172, 447-457. Comparison of Dunaliella primolecta in 0.30 M NaHCO₃ against bubbling with 2 % CO₂: no significant difference. ↩︎

  6. Bicarbonate at 0.1-1 mol/l against a medium sparged with gas containing a few percent CO₂ (~1.7 mmol/l at 5 % CO₂, 25 °C, Henry’s constant 0.034 mol/l/atm): a ratio of roughly 60 to 600×. Against water in equilibrium with ambient air (~14 µmol/l) the difference is four orders of magnitude. We quote the more conservative comparison. ↩︎

  7. Cultivating spirulina in open ponds at high pH is established industrial practice. It is also confirmed by the cyanobacterial consortium study of Ataeian et al. (2019) at an alkalinity of 0.5 mol/l and a pH swing of 10.4-11.2, productivity 15.2 ± 1.0 g/m²/day. High pH acts as selection pressure against contamination. ↩︎

  8. Alkalihalophilic strains grow routinely at pH 9 to 11. For unadapted Chlorella vulgaris that band lies beyond the usual optimum and adaptation is necessary. ↩︎

  9. Chi, Z., Xie, Y., Elloy, F., Zheng, Y., Hu, Y., Chen, S. (2013). Bicarbonate-based Integrated Carbon Capture and Algae Production System with alkalihalophilic cyanobacterium. Bioresource Technology, 133, 513-521. DOI 10.1016/j.biortech.2013.01.150. The working pH band is also confirmed by Ataeian et al. (2019): a cyanobacterial consortium at an alkalinity of 0.5 mol/l with a pH swing between 10.4 and 11.2 between growth and harvest, productivity 15.2 ± 1.0 g/m²/day. ↩︎

  10. In an alkaline, bicarbonate-rich environment what limits the process is not the amount of carbon but the rate of its conversion to CO₂ at the cell. Supplementing carbonic anhydrase (a zinc enzyme) raised the specific growth rate by 21-82 % in digestate cultures, measured in Erlenmeyer flasks. In a semi-continuous, operationally relevant regime the effect was not statistically confirmed. Berden-Zrimec et al. (2026), Phycology 6(1), 23. ↩︎

  11. Zhu, C., Zhang, R., Cheng, L., Chi, Z. (2018). A recycling culture of Neochloris oleoabundans in a bicarbonate-based integrated carbon capture and algae production system with harvesting by auto-flocculation. Biotechnology for Biofuels, 11, 204. Alkaline flocculation induced by a rise in pH: recovery 97.4 ± 0.21 % at 0.7 mol/l bicarbonate, 97.7 ± 0.29 % with 20 mM Ca²⁺ added. Highest productivity at 0.3 mol/l, highest carbon utilisation at 0.1 mol/l. ↩︎